HVAC Near You
Call
Furnace Repair · Near Me

Furnace Repair in Andrews

Get fast, fair pricing from licensed local pros. Typical Andrews cost: $75 – $225 installed.

Call now: (855) 321-3116
Licensed & insured Upfront pricing Same-day service
Flame sensor
$75 – $225
Igniter
$125 – $400
Blower motor
$375 – $1.4k
Control board
$275 – $750
0%sizing
Dialing inStep 1 of 3
Instant cost estimate

What's going on with your HVAC system?

  • Licensed
    & fully insured
  • Same-day
    service available
  • Upfront
    pricing, no pressure
  • Local
    pros, nationwide
Andrews pricing

Furnace repair cost by part.

Typical Andrews repair pricing including parts and labor. A diagnostic fee usually applies and is often credited toward the work.

In Andrews, Texas, furnace repair costs typically range from $75 for a simple flame sensor replacement to over $3,200 for a heat exchanger. With a median home age of 52 years, many furnaces are older and may need more frequent repairs. Texas requires a TDLR-licensed contractor to pull a mechanical permit for any furnace work, which adds to the overall cost. The hot-humid climate means cooling demand is high, so a heat pump is often a strong fit for year-round comfort. Local labor rates and the need for permits influence pricing, and homeowners should budget for a diagnostic fee of $70–$175.

  • Diagnostic / service call
    Often credited toward the repair
    $70 – $175
  • Flame sensor or thermocouple
    Common no-heat cause on gas units
    $75 – $225
  • Hot-surface igniter
    Furnace clicks but won’t light
    $125 – $400
  • Blower motor
    No airflow / weak airflow
    $375 – $1,350
  • Heat exchanger
    Cracked exchanger often means replace
    $1,350 – $3,200+

* A cracked heat exchanger is a safety issue — on an older furnace, replacement is usually the call.

Pricing reviewed · Local data from U.S. Census ACS

HVAC systems in Andrews

U.S. Census ACS
Households
5,337
Homeowners
3,488
67% own
Median home value
$177,300
Median income
$86,806
Median home built
1974
Housing units
5,231

With a median home built in 1974, many Andrews AC and furnace systems are at or past their 12–15 year lifespan — a common reason replacements spike here.

Talk to a local pro

Ready to get your HVAC system serviced in Andrews?

Speak with a licensed, insured HVAC technician near you. Upfront pricing, same-day availability, no obligation.

  • Licensed & insured
  • Same-day availability
  • Upfront, no-pressure pricing
  • Local pros near you
Call now: (855) 321-3116

No obligation — talk through your options.

Licensed technician servicing an HVAC system
Local guide · Andrews

What’s different about Andrews.

Generic cost pages skip the things that actually decide your price and which system fits here — local code, climate, and the money you can claim back.

Recommended unit for Andrews

High-SEER2 heat pump

Given Texas’s hot-humid climate and mixed heating, high-seer2 heat pump is the sensible default for most Andrews homes. With a long, hard cooling season here, stepping up the SEER2 tier pays back through lower summer bills. A pro can confirm the right size and system for your home with a load calculation.

Sources: SEER2 Southeast region standards (Texas) · Texas heat pump rebates by utility 2026 · Texas HVAC permit requirements

What Andrews code requires

Installing or replacing an HVAC system in Andrews follows Texas rules under the state mechanical code. Here’s what applies statewide:

  • Permit

    Mechanical permit pulled by your licensed HVAC contractor; covers equipment, refrigerant, and the electrical disconnect.

    Required
  • SEER2 minimum

    Federal Southeast-region minimum for new split-system AC. Higher tiers cut bills and unlock rebates.

    14.3 SEER2 (Southeast, <45k BTU)
  • Load calculation

    Sizing by load calc — not rule of thumb — prevents an oversized unit that short-cycles and never dehumidifies.

    Recommended
  • Refrigerant
    R-454B / R-32 (R-410A phased down 2025+)
  • Good to know

    HVAC work must be done by a TDLR-licensed Air Conditioning & Refrigeration contractor, and the licensed contractor (not the homeowner) pulls the required mechanical permit.

    —

Sources: SEER2 Southeast region standards (Texas) · Texas heat pump rebates by utility 2026 · Texas HVAC permit requirements

Talk to a local pro

Not sure which rules and rebates apply to your home?

A licensed Andrews pro will walk you through code, the right unit, and what you can claim back — in one quick call.

Call now: (855) 321-3116

No obligation — talk through your options.

Money back in Andrews

Texas heating is mostly mixed, which shapes the money back:

The federal 25C tax credit (30%, up to $2,000 for a qualifying heat pump and up to $600 for a high-efficiency central AC) applies in every state, including Texas.

How it works

Comfort back in three steps.

  1. 1

    Tell us what’s wrong

    Use the cost tool or call — takes 30 seconds. No cool air, no heat, or time for a new system.

  2. 2

    Get matched with a local pro

    We connect you with a licensed, insured HVAC technician near you — often the same day.

  3. 3

    Repair or replace, fast

    Your pro confirms the price on-site and gets your comfort back. Most jobs done in a few hours.

Local insight · Andrews

Furnace Repair in Andrews, explained.

What moves the price

What affects furnace repair costs in Andrews?

Repair costs vary based on the part needed—flame sensors and igniters are more affordable, while blower motors and heat exchangers cost more. The age of your furnace (median 1974) may require harder-to-find parts. Labor rates in Andrews reflect the local market, and the required mechanical permit adds a fee. The choice of a heat pump over a standard furnace can also influence long-term costs.

Common furnace repairs in Andrews

1

Flame sensor failure

A dirty or faulty flame sensor can cause the furnace to shut off after ignition. Cleaning or replacing it costs $75–$225.

2

Igniter problems

A broken igniter prevents the furnace from lighting. Replacement typically runs $125–$400.

3

Blower motor issues

A failing blower motor reduces airflow. Repair or replacement costs $375–$1,350.

FAQ

Furnace Repair FAQs — Andrews

Yes, Texas requires a mechanical permit for furnace work. A TDLR-licensed contractor must pull the permit, which adds to the total cost.

Furnace Repair near Andrews

Get a furnace repair quote.

No heat? Compare licensed local pros fast.

(855) 321-3116 Available now · Same-day service
Call now: (855) 321-3116

Upfront pricing Same-day Licensed