HVAC Near You
Call
Furnace Repair · Near Me

Furnace Repair in Midvale

Get fast, fair pricing from licensed local pros. Typical Midvale cost: $75 – $225 installed.

Licensed & insured Upfront pricing Same-day service
Flame sensor
$75 – $225
Igniter
$150 – $425
Blower motor
$375 – $1.4k
Control board
$275 – $750
0%sizing
Dialing inStep 1 of 3
Instant cost estimate

What's going on with your HVAC system?

  • Licensed
    & fully insured
  • Same-day
    service available
  • Upfront
    pricing, no pressure
  • Local
    pros, nationwide
Midvale pricing

Furnace repair cost by part.

Typical Midvale repair pricing including parts and labor. A diagnostic fee usually applies and is often credited toward the work.

Furnace repair in Midvale, Utah typically costs between $75 and $3,200+, depending on the component. The median home was built in 1984, so many systems are aging and may need repairs like flame sensor or igniter replacement. A diagnostic fee of $70–$175 is standard. Utah requires a mechanical permit for furnace work, which adds to the total cost. Midvale's cold-dry high-desert climate means heating loads are significant, so proper sizing is critical. Most homes use gas furnaces, and a gas furnace with AC is a common setup.

  • Diagnostic / service call
    Often credited toward the repair
    $70 – $175
  • Flame sensor or thermocouple
    Common no-heat cause on gas units
    $75 – $225
  • Hot-surface igniter
    Furnace clicks but won’t light
    $150 – $425
  • Blower motor
    No airflow / weak airflow
    $375 – $1,400
  • Heat exchanger
    Cracked exchanger often means replace
    $1,400 – $3,200+

* A cracked heat exchanger is a safety issue — on an older furnace, replacement is usually the call.

Pricing reviewed · Local data from U.S. Census ACS

HVAC systems in Midvale

U.S. Census ACS
Households
14,244
Homeowners
6,724
43% own
Median home value
$357,200
Median income
$70,742
Median home built
1984
Housing units
15,809

With a median home built in 1984, many Midvale AC and furnace systems are at or past their 12–15 year lifespan — a common reason replacements spike here.

Talk to a local pro

Ready to get your HVAC system serviced in Midvale?

Speak with a licensed, insured HVAC technician near you. Upfront pricing, same-day availability, no obligation.

  • Licensed & insured
  • Same-day availability
  • Upfront, no-pressure pricing
  • Local pros near you
Call now: (855) 321-3116

No obligation — talk through your options.

Licensed technician servicing an HVAC system
Local guide · Midvale

What’s different about Midvale.

Generic cost pages skip the things that actually decide your price and which system fits here — local code, climate, and the money you can claim back.

Recommended unit for Midvale

High-SEER2 AC + gas furnace

Given Utah’s cold-dry climate and gas heating, high-seer2 ac + gas furnace is the sensible default for most Midvale homes. A pro can confirm the right size and system for your home with a load calculation.

Sources: Rocky Mountain Power - Savings & Energy Choices for Homes (Wattsmart) · SEER2 North Region efficiency standards · EIA Utah electricity profile

What Midvale code requires

Installing or replacing an HVAC system in Midvale follows Utah rules under the state mechanical code. Here’s what applies statewide:

  • Permit

    Mechanical permit pulled by your licensed HVAC contractor; covers equipment, refrigerant, and the electrical disconnect.

    Required
  • SEER2 minimum

    Federal North-region minimum for new split-system AC. Higher tiers cut bills and unlock rebates.

    13.4 SEER2 (North)
  • Load calculation

    Sizing by load calc — not rule of thumb — prevents an oversized unit that short-cycles and never dehumidifies.

    Recommended
  • Refrigerant
    R-454B / R-32 (R-410A phased down 2025+)
  • Good to know

    Cold-dry high-desert climate: equipment should be sized for hard winter heating loads, and a cold-climate (NEEP-listed) heat pump is required to earn the top Rocky Mountain Power Wattsmart rebate.

Sources: Rocky Mountain Power - Savings & Energy Choices for Homes (Wattsmart) · SEER2 North Region efficiency standards · EIA Utah electricity profile

Talk to a local pro

Not sure which rules and rebates apply to your home?

A licensed Midvale pro will walk you through code, the right unit, and what you can claim back — in one quick call.

Call now: (855) 321-3116

No obligation — talk through your options.

Money back in Midvale

Utah heating is mostly gas, which shapes the money back:

The federal 25C tax credit (30%, up to $2,000 for a qualifying heat pump and up to $600 for a high-efficiency central AC) applies in every state, though it is set to expire after 2025.

How it works

Comfort back in three steps.

  1. 1

    Tell us what’s wrong

    Use the cost tool or call — takes 30 seconds. No cool air, no heat, or time for a new system.

  2. 2

    Get matched with a local pro

    We connect you with a licensed, insured HVAC technician near you — often the same day.

  3. 3

    Repair or replace, fast

    Your pro confirms the price on-site and gets your comfort back. Most jobs done in a few hours.

Local insight · Midvale

Furnace Repair in Midvale, explained.

What moves the price

What Affects Furnace Repair Costs in Midvale

Prices vary by the part needing replacement: flame sensor ($75–$225), igniter ($150–$425), blower motor ($375–$1,400), control board ($275–$750), or heat exchanger ($1,400–$3,200+). Labor rates reflect local costs, and a mechanical permit from the city adds a fee. The age of your system (median 42 years) may make repairs more complex. Emergency or after-hours service can also increase the price.

Common Furnace Problems in Midvale

1

Flame Sensor Failure

A dirty or faulty flame sensor can cause the furnace to shut off after ignition. Cleaning or replacing it costs $75–$225.

2

Igniter Malfunction

A broken igniter prevents the furnace from lighting. Replacement runs $150–$425.

3

Blower Motor Issues

A failing blower motor reduces airflow and heating efficiency. Repair or replacement costs $375–$1,400.

FAQ

Furnace Repair FAQs — Midvale

Yes, Utah requires a mechanical permit for most furnace repairs. Your contractor should obtain it, and the cost is typically included in the estimate.

Furnace Repair near Midvale

Get a furnace repair quote.

No heat? Compare licensed local pros fast.

(855) 321-3116 Available now · Same-day service
Call now: (855) 321-3116

Upfront pricing Same-day Licensed