HVAC Near You
Call
Furnace Repair · Near Me

Furnace Repair in Roma

Get fast, fair pricing from licensed local pros. Typical Roma cost: $60 – $200 installed.

Call now: (855) 321-3116
Licensed & insured Upfront pricing Same-day service
Flame sensor
$60 – $200
Igniter
$125 – $350
Blower motor
$300 – $1.1k
Control board
$225 – $600
0%sizing
Dialing inStep 1 of 3
Instant cost estimate

What's going on with your HVAC system?

  • Licensed
    & fully insured
  • Same-day
    service available
  • Upfront
    pricing, no pressure
  • Local
    pros, nationwide
Roma pricing

Furnace repair cost by part.

Typical Roma repair pricing including parts and labor. A diagnostic fee usually applies and is often credited toward the work.

Furnace repair in Roma, Texas, typically costs between $60 and $2,700 depending on the part. With a median home age of 37 years, older furnaces often need more frequent repairs. Local labor rates reflect the area's median household income of $26,951, and a diagnostic fee of $55–$150 applies. Texas requires a TDLR-licensed contractor to pull a mechanical permit for any furnace work, which adds a small overhead. Given Roma's hot-humid climate and mixed heating needs, a heat pump is often recommended for both heating and cooling, though furnace repairs remain common for existing systems.

  • Diagnostic / service call
    Often credited toward the repair
    $55 – $150
  • Flame sensor or thermocouple
    Common no-heat cause on gas units
    $60 – $200
  • Hot-surface igniter
    Furnace clicks but won’t light
    $125 – $350
  • Blower motor
    No airflow / weak airflow
    $300 – $1,150
  • Heat exchanger
    Cracked exchanger often means replace
    $1,150 – $2,700+

* A cracked heat exchanger is a safety issue — on an older furnace, replacement is usually the call.

Pricing reviewed · Local data from U.S. Census ACS

HVAC systems in Roma

U.S. Census ACS
Households
4,612
Homeowners
1,981
49% own
Median home value
$77,400
Median income
$26,951
Median home built
1989
Housing units
4,082

With a median home built in 1989, many Roma AC and furnace systems are at or past their 12–15 year lifespan — a common reason replacements spike here.

Talk to a local pro

Ready to get your HVAC system serviced in Roma?

Speak with a licensed, insured HVAC technician near you. Upfront pricing, same-day availability, no obligation.

  • Licensed & insured
  • Same-day availability
  • Upfront, no-pressure pricing
  • Local pros near you
Call now: (855) 321-3116

No obligation — talk through your options.

Licensed technician servicing an HVAC system
Local guide · Roma

What’s different about Roma.

Generic cost pages skip the things that actually decide your price and which system fits here — local code, climate, and the money you can claim back.

Recommended unit for Roma

High-SEER2 heat pump

Given Texas’s hot-humid climate and mixed heating, high-seer2 heat pump is the sensible default for most Roma homes. With a long, hard cooling season here, stepping up the SEER2 tier pays back through lower summer bills. A pro can confirm the right size and system for your home with a load calculation.

Sources: SEER2 Southeast region standards (Texas) · Texas heat pump rebates by utility 2026 · Texas HVAC permit requirements

What Roma code requires

Installing or replacing an HVAC system in Roma follows Texas rules under the state mechanical code. Here’s what applies statewide:

  • Permit

    Mechanical permit pulled by your licensed HVAC contractor; covers equipment, refrigerant, and the electrical disconnect.

    Required
  • SEER2 minimum

    Federal Southeast-region minimum for new split-system AC. Higher tiers cut bills and unlock rebates.

    14.3 SEER2 (Southeast, <45k BTU)
  • Load calculation

    Sizing by load calc — not rule of thumb — prevents an oversized unit that short-cycles and never dehumidifies.

    Recommended
  • Refrigerant
    R-454B / R-32 (R-410A phased down 2025+)
  • Good to know

    HVAC work must be done by a TDLR-licensed Air Conditioning & Refrigeration contractor, and the licensed contractor (not the homeowner) pulls the required mechanical permit.

    —

Sources: SEER2 Southeast region standards (Texas) · Texas heat pump rebates by utility 2026 · Texas HVAC permit requirements

Talk to a local pro

Not sure which rules and rebates apply to your home?

A licensed Roma pro will walk you through code, the right unit, and what you can claim back — in one quick call.

Call now: (855) 321-3116

No obligation — talk through your options.

Money back in Roma

Texas heating is mostly mixed, which shapes the money back:

The federal 25C tax credit (30%, up to $2,000 for a qualifying heat pump and up to $600 for a high-efficiency central AC) applies in every state, including Texas.

How it works

Comfort back in three steps.

  1. 1

    Tell us what’s wrong

    Use the cost tool or call — takes 30 seconds. No cool air, no heat, or time for a new system.

  2. 2

    Get matched with a local pro

    We connect you with a licensed, insured HVAC technician near you — often the same day.

  3. 3

    Repair or replace, fast

    Your pro confirms the price on-site and gets your comfort back. Most jobs done in a few hours.

Local insight · Roma

Furnace Repair in Roma, explained.

What moves the price

What affects furnace repair costs in Roma?

The main price drivers are the specific part needed and labor time. Common repairs range from a $60–$200 flame sensor to a $1,150–$2,700+ heat exchanger. Older homes (median built 1989) may have harder-to-source parts or require more labor. The mandatory permit from the City of Roma or county adds a small fee. Seasonal demand in Roma's hot-humid climate can also affect availability and pricing.

Common furnace repairs in Roma

1

Flame sensor failure

A dirty or faulty flame sensor causes the furnace to cycle on and off. Repair cost: $60–$200.

2

Igniter problems

A broken igniter prevents the furnace from lighting. Replacement runs $125–$350.

3

Blower motor issues

A worn blower motor reduces airflow. Replacement costs $300–$1,150.

FAQ

Furnace Repair FAQs — Roma

Yes, Texas law requires a mechanical permit for any furnace repair that involves replacing parts. A TDLR-licensed contractor must pull the permit.

Furnace Repair near Roma

Get a furnace repair quote.

No heat? Compare licensed local pros fast.

(855) 321-3116 Available now · Same-day service
Call now: (855) 321-3116

Upfront pricing Same-day Licensed