Do I need a permit to install AC in Selma?

Mechanical permit pulled by your licensed HVAC contractor; covers equipment, refrigerant, and the electrical disconnect. In almost every Texas jurisdiction a mechanical permit is required for an AC or heat pump install. Your licensed contractor pulls it, and it covers the equipment, refrigerant handling, and the electrical disconnect.

Should I repair or replace my HVAC system in Selma?

If the system is under about 10–12 years old and the fault is a part — a capacitor, igniter, or motor — repair usually wins. If the compressor or heat exchanger fails, the system uses phased-out R-22 refrigerant, or it’s past 12–18 years, replacement is the smarter spend. A local Selma pro can confirm which way to go on-site.

How long does an AC or furnace installation take in Selma?

A like-for-like central AC or furnace swap is usually one day, so most Selma jobs are completed same-day. Adding ductwork, switching system types, or a multi-zone mini-split can take two to three days.

HVAC services · Selma, Texas

HVAC services in Selma, TX

Q: How much does HVAC service cost in Selma?

In Selma, AC and furnace repairs typically run $150 – $1,400+ including parts and labor. A central AC replacement runs $3,700 – $7,500+ installed, heat pumps $4,700 – $11,000+, and a seasonal tune-up $70 – $175. Prices are adjusted for local labor and shift with system type and code upgrades.

Q: Which HVAC rebates can I get in Selma?

The federal 25C tax credit (30%, up to $2,000 for a qualifying heat pump and up to $600 for a high-efficiency central AC) applies in every state, including Texas. Federal 25C credits add 30% of cost (up to $2,000 for a heat pump, $600 for a high-efficiency AC) on top.

AC repair, furnace repair, installation, and tune-ups from licensed local pros near you. Same-day help when your system quits.

Call now: (855) 321-3116

No-obligation estimate Licensed & insured · Same-day

Pricing reviewed June 2026 · Local data from U.S. Census ACS

0%sizing

Dialing inStep 1 of 3

Instant cost estimate

What's going on with your HVAC system?

Licensed
& fully insured
Same-day
service available
Upfront
pricing, no pressure
Local
pros, nationwide

Choose your job

Selma HVAC services

AC Repair

$150 – $1.4k+

AC repair cost depends on the failing part and whether the system is low on refrigerant, electrical, or mechanical. Common fixes — capacitors, contactors, fan motors, refrigerant recharges — land between $150 and $1,500 including labor, while a failed compressor runs higher.

View Selma pricing →

Furnace Repair

$150 – $1.7k+

Furnace repair cost depends on the failing part and whether the unit is gas or electric. Common fixes — flame sensors, igniters, blower motors, control boards — land between $150 and $1,800 including labor, while a cracked heat exchanger runs higher.

View Selma pricing →

AC Installation

$3.3k – $8.4k+

AC installation cost covers the equipment and labor to fit a new system — whether it's a like-for-like central AC replacement, a first-time install with new ductwork, or a ductless mini-split. The number swings with tonnage, SEER2 efficiency tier, and duct condition.

View Selma pricing →

AC Maintenance

$70 – $175

AC maintenance — a seasonal tune-up — keeps the system running efficiently and catches small faults before they become summer breakdowns. A single visit runs $75–$200; annual plans that bundle a spring AC and fall heating check cost a bit more.

View Selma pricing →

HVAC systems in Selma

U.S. Census ACS

Households: 4,427
Homeowners: 2,192; 55% own
Median home value: $262,000
Median income: $95,692
Median home built: 2010
Housing units: 4,023

With a median home built in 2010, many Selma AC and furnace systems are at or past their 12–15 year lifespan — a common reason replacements spike here.

Selma cost guide

HVAC cost in Selma.

Homes in Selma were built around 2010 on average — roughly 16 years ago. Because a central AC or furnace typically lasts 12–18 years, a large share of Selma systems are now at or past the point where another repair stops paying off and replacement becomes the smarter spend.

Installing or replacing an HVAC system in Selma follows Texas rules under the state mechanical code. Here’s what applies statewide:

Local labor rates and Texas permitting shape the final number. Based on area incomes and cost tier, Selma installs tend to land slightly below the national average — the cost table below is adjusted to match.

HVAC cost by service in Selma
Type / job	Typical Selma cost	Good for
AC repair (common fault)Capacitor, refrigerant, fan motor	$150 – $1,400+	Capacitor, refrigerant, fan motor
Furnace repair (common fault)Igniter, flame sensor, blower	$150 – $1,700+	Igniter, flame sensor, blower
Central AC (replace, like-for-like)Existing ducts in good shape	$3,700 – $7,500+	Existing ducts in good shape
Heat pump (cooling + heating)Qualifies for federal & utility rebates	$4,700 – $11,000+	Qualifies for federal & utility rebates
Ductless mini-splitNo ducts; single or multi-zone	$2,800 – $7,500	No ducts; single or multi-zone
AC tune-up / maintenanceSeasonal service visit	$70 – $175	Seasonal service visit
Permit & inspectionRequired in most jurisdictions	$70 – $375	Required in most jurisdictions

Pricing reviewed June 2026 · Adjusted for Selma labor ratesLocal data · U.S. Census ACS

Installed prices including labor. Code upgrades, ductwork, and higher-tonnage or higher-SEER2 systems move the number up.

Local guide · Selma

What’s different about Selma.

Generic cost pages skip the things that actually decide your price and which system fits here — local code, climate, and the money you can claim back.

Recommended unit for Selma

High-SEER2 heat pump

Given Texas’s hot-humid climate and mixed heating, high-seer2 heat pump is the sensible default for most Selma homes. With a long, hard cooling season here, stepping up the SEER2 tier pays back through lower summer bills. A pro can confirm the right size and system for your home with a load calculation.

Sources: SEER2 Southeast region standards (Texas) · Texas heat pump rebates by utility 2026 · Texas HVAC permit requirements

What Selma code requires

Installing or replacing an HVAC system in Selma follows Texas rules under the state mechanical code. Here’s what applies statewide:

Permit
Mechanical permit pulled by your licensed HVAC contractor; covers equipment, refrigerant, and the electrical disconnect.
Required
SEER2 minimum
Federal Southeast-region minimum for new split-system AC. Higher tiers cut bills and unlock rebates.
14.3 SEER2 (Southeast, <45k BTU)
Load calculation
Sizing by load calc — not rule of thumb — prevents an oversized unit that short-cycles and never dehumidifies.
Recommended
Refrigerant
R-454B / R-32 (R-410A phased down 2025+)
Good to know
HVAC work must be done by a TDLR-licensed Air Conditioning & Refrigeration contractor, and the licensed contractor (not the homeowner) pulls the required mechanical permit.
—

Sources: SEER2 Southeast region standards (Texas) · Texas heat pump rebates by utility 2026 · Texas HVAC permit requirements

Talk to a local pro

Not sure which rules and rebates apply to your home?

A licensed Selma pro will walk you through code, the right unit, and what you can claim back — in one quick call.

Call now: (855) 321-3116

No obligation — talk through your options.

Money back in Selma

Texas heating is mostly mixed, which shapes the money back:

State
up to ~$3,000 (ENERGY STAR heat pump, participating contractor)
Austin Energy Home Energy Improvement / Power Saver heat pump rebate →
State or utility program — verify eligibility before you buy.
State
approx $100-$275 per ton
CPS Energy heat pump / high-efficiency AC rebate (SEER2 15.2+) →
State or utility program — verify eligibility before you buy.
State
up to ~$600 (ENERGY STAR equipment, licensed contractor)
Oncor Take a Load Off Texas energy efficiency program →
State or utility program — verify eligibility before you buy.
Federal
30% of cost, up to $2,000
Federal 25C tax credit — heat pump →
For a qualifying ENERGY STAR heat pump meeting the CEE efficiency tier. Claimed on your federal return.

The federal 25C tax credit (30%, up to $2,000 for a qualifying heat pump and up to $600 for a high-efficiency central AC) applies in every state, including Texas.

How it works

Comfort back in three steps.

1
Tell us what’s wrong
Use the cost tool or call — takes 30 seconds. No cool air, no heat, or time for a new system.
2
Get matched with a local pro
We connect you with a licensed, insured HVAC technician near you — often the same day.
3
Repair or replace, fast
Your pro confirms the price on-site and gets your comfort back. Most jobs done in a few hours.

FAQ

HVAC FAQs — Selma

In Selma, AC and furnace repairs typically run $150 – $1,400+ including parts and labor. A central AC replacement runs $3,700 – $7,500+ installed, heat pumps $4,700 – $11,000+, and a seasonal tune-up $70 – $175. Prices are adjusted for local labor and shift with system type and code upgrades.

HVAC services near Selma

Need HVAC service in Selma?

Talk to a licensed local pro now — no obligation, no pressure.

(855) 321-3116 Available now · Same-day service

HVAC services in Selma, TX

What's going on with your HVAC system?

Selma HVAC services

AC Repair

Furnace Repair

AC Installation

AC Maintenance

HVAC systems in Selma

HVAC cost in Selma.

What’s different about Selma.

Recommended unit for Selma

What Selma code requires

Not sure which rules and rebates apply to your home?

Money back in Selma

Comfort back in three steps.

Tell us what’s wrong

Get matched with a local pro

Repair or replace, fast

HVAC FAQs — Selma

HVAC services near Selma

Need HVAC service in Selma?